Poodle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
592 Posts
No problem. It shifted, or perhaps was assembled out of alignment. You set it straight. I don’t anticipate anything is damaged. Just check to ensure the screws are not excessively loose.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
592 Posts
thank you, my fear now that it is up, it can go left,right, even with the other teeth not sure where the proper alignment should be
Here is a video for Wahl two hole blades:


Here is the FAQ for animal blades. In my experience, if you make the "1" dimension too small, the blade may clog. If that occurs, take it apart, clean out the clog, and set the "1" dimension a little larger.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top